Loading Envelopes In Tray 5 (Bypass) - Xerox Versant 280 Press Quick Start Manual

Loading Envelopes in Tray 5 (Bypass)

It is recommended that you print envelopes from the Bypass (Tray 5). If you are required to print
envelopes from the optional Trays 6 and 7, use the Postcard Bracket.
Note: For information on supported envelope types and sizes, refer to the Customer
Expectation and Installation Guide.
When setting up your print job, select from the following options:
• Envelope Feeder: used for standard-sized envelopes
• Change Settings: used for custom-sized envelopes
Note: Store unused envelopes in their original packaging to avoid the excess moisture or
dryness that can affect print quality and cause wrinkling. Excessive moisture can cause the
envelopes to seal before or during printing.
Some wrinkling or embossing can occur when printing on envelopes. Successful envelope printing
depends on the quality and construction of the envelopes. Try another envelope brand if problems
occur.
When defining custom paper settings at the Paper Tray settings/Tray Properties window, assign the
custom stock to the Bypass Tray (Tray 5) or an Advanced Oversized High Capacity Feeder (Tray 6 or
7). Select Auto Detect for automatic size-detection or measure the height and width of the envelope
with the flap closed, then enter the dimensions. For more detailed information, refer to the following
steps.
1. Always load envelopes with the flaps closed.
Do not use padded envelopes.
2. When loading in the SEF direction, place the flaps facing the back of the press. When loading in
the LEF direction, place the flaps facing the lead edge.
3. When submitting your network print file, select Custom Paper as the Paper Type. Enter the
dimensions of the envelope.
Measure the width from the lead edge to the trail edge of the envelope. For example, if you load
SEF, enter the long dimension of the envelope as the width. If you load the envelope LEF, enter
the short dimension of the envelope as the width.
4. Enter a heavy paper weight value, such as 220 g/m
A paper weight of 220 is a good starting point. If the printing is blurred or smeared, enter a
higher value.
5. Select the Bypass Tray (Tray 5) as the Paper Source.
2 in the Paper Weight field.
Xerox ® Versant
Paper and Media
® 280 Press 19
Quick Start Guide