Putting A Conference Call On Hold And Resuming A Call; Dropping Or Disconnecting The Last Participant From A Conference Call - Avaya J139 Using Manual

• OK
The held call is added to the conference call.

Putting a conference call on hold and resuming a call

About this task
Use this procedure to put a conference participant on hold, while other participants continue the
conference call.
Procedure
1. Press Hold soft key during a conference call.
2. Do one of the following:
• Press Resume.
• Select the call appearance to resume the conference call.
Dropping or Disconnecting the last participant from a
conference call
About this task
Depending on the configuration made by your administrator, you can disconnect the last
participant who joined the conference call. After you disconnect the last participant, you cannot
disconnect other participants. You can disconnect a participant again after you add another
participant to the conference call.
Before you begin
Ensure that the feature is activated by the administrator. Contact your administrator for details.
Procedure
1. From the phone screen, select your active conference call.
You will see the More soft key.
2. Press More > Drop when the conference is active.
Result
The participant who was added last gets disconnected from the conference.
Related links
Adding a participant to no hold conference
February 2021
Putting a conference call on hold and resuming a call
on page 79
Using Avaya J139 SIP IP Phone in Avaya Aura
Comments on this document? infodev@avaya.com
®
51