Putting A Conference Call On Hold And Resuming A Call; Dropping Or Disconnecting The Last Participant From A Conference Call - Avaya J189 Manual

• Ok
The held call is added to the conference call.

Putting a conference call on hold and resuming a call

About this task
Use this procedure to put a conference participant on hold, while other participants continue the
conference call.
Procedure
1. Press Hold soft key during a conference call.
2. Do one of the following:
• Press Resume.
• Select the call appearance to resume the conference call.
Dropping or Disconnecting the last participant from a
conference call
About this task
You can use this procedure to disconnect the last participant who joined the conference. You
cannot disconnect other participants after you disconnect the last participant. You can use this
method to disconnect a participant again after you add another participant.
Procedure
1. From the phone screen, select your active conference call.
You will see the More soft key.
2. Press End Call when the conference is active.
Result
The participant who was added last gets disconnected from the conference.
Related links
Adding a participant to no hold conference
August 2020
Putting a conference call on hold and resuming a call
on page 86
Using Avaya J189 IP Phone SIP
Comments on this document? infodev@avaya.com
53