Removing Wash Motor & Rotating Inlet Filter - KitchenAid KMTM704E Series Technical Education

Removing Wash Motor & Rotating Inlet Filter
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Removing the Wash Motor
1. Unplug dishwasher or disconnect power.
2. If not done already, disconnect the wash motor harness.
(See figure 1.)
Remove Harness
Figure 1
3. Remove clamp from sump side of hose (see Figure 2).
1. Unplug dishwasher or disconnect power.
4. Use a screwdriver to gently loosen the seal between the
grommet and the sump assembly (see Figure 3).
5. Pull down slightly on wash motor so that the isolator tube
(see Figure 4) clears the sump edge gasket.
KitchenAid 2015 Microfiltration Dishwashers
COMPONENT ACCESS
Figure 2
Figure 3
Isolator Tube
Pull DOWN and OUT
Figure 4
4-27
n