Table of Contents
Advertisement
12
C
1: G
HAPTER
ETTING
Powering the
Phone On and Off
About
Power-Saving
Mode
Care and
Maintenance
S
TARTED
To install and charge the battery:
1 Remove the rear cover on the handset (See
2 Insert the battery in the compartment so that the metal contacts on the
battery and handset are aligned.
3 Replace the rear cover of the handset.
4 Plug the AC power adapter into the USB Data Cable slot on the bottom
of the handset. (See
5 Plug the other end of the power adapter into the appropriate AC outlet.
WARNING: When you connect the country-specific power supply
adapter, always connect the adapter to the power supply before you
connect to the wall outlet.
For first time usage, you should charge the battery for at least 8 hours.
While the phone is charging, you can still do phone operations according
the instructions in this guide. The battery charging status is accurate only
after uninterrupted charging/ discharging. The battery can get warm
during charging. This is not a malfunction. If the battery is completely
exhausted, you need to charge the battery for approximately three hours
(with the phone powered off) to reach full capacity.
You use the same key to power the phone on and off.
To power On the phone — press and hold the
To power OFF the phone — press and hold the
To minimize power consumption, the LCD display automatically goes dim
after 15 seconds (default setting) without any operations. You can
change this setting to 30 Seconds or Always On. For details, see LCD
Off Time in the
"Settings"
To reactivate the LCD display, press any key.
Note the following tips to keep your phone in proper operating
condition:
Keep your phone and accessories away from dusty, wet or dirty areas.
Figure 2
on page
page
menu described on
Figure 1
on page
page
17.)
Power key.
Power key.
page
49.
16.)
Advertisement
Table of Contents
