Modem Setup; Setting The Modem Port Baud Rate; Connecting To An External Modem - 3Com CoreBuilder 2500 Getting Started Manual

6-4 C 6: Q S
HAPTER UICK

Modem Setup

You can set up your system for modem access
through an external modem attached to the system
processor's modem port. To do this, you must first
set the baud rate of the modem port (if necessary),
and then attach and configure your external
modem.

Setting the Modem Port Baud Rate

Your CoreBuilder system is shipped with the
following modem serial port parameters set as
defaults: 9600 baud, 8 bits, no parity, 1 stop bit.
To change the baud rate of the modem port from
the Administration Console:
From the top level of the Administration Console at
1
the
Select a menu option
system
At the System menu, enter:
2
serialPort
At the SerialPort menu, enter:
3
modemSpeed
At the prompt, enter the baud rate for the modem
4
port. The system supports these baud rates: 19200,
9600, 4800, 2400, 1200, and 300.
M A
ETUP FOR ANAGEMENT CCESS
prompt, enter:

Connecting to an External Modem

To connect to and configure the external modem
port:
From the top level of the Administration Console at
1
the
Select a menu option
system
At the System menu, enter:
2
serialPort
At the SerialPort menu, enter:
3
connectModem
You can now issue the commands to the attached
modem that support whatever communication
parameters are appropriate to your installation. All
characters you enter in the Console are transmitted
to the modem port.
To break the connection, enter the escape
4
sequence with no intervening characters.
~]
When you enter the escape sequence, the
connection to the modem port is broken and you
are returned to the previous menu.
prompt, enter: