10Base-2 (Bnc) Module; 10Base-2 (Bnc) Configuration - 3Com CoreBuilder 2500 Getting Started Manual

4-12 C 4: C
HAPTER ABLING
To cable the 10BASE-FL module:
Remove the protective plastic covers from the
1
module's fiber optic ports and from the ends of the
connectors on each fiber strand.
Locate the fiber attached to the receiver of the
2
remote 10BASE-FL transceiver/system and connect
it to the selected transmitter port on the module.
Locate the fiber attached to the transmitter of the
3
remote 10BASE-FL receiver/system and connect it to
the selected receiver port on the module.
Repeat steps 1 through 3 for the remaining ports.
4
Figure 4-12 shows the cabling of the 10BASE-FL
module using 10BASE-FL cabling.
Transmitter (Port 8)
PCMCIA
Inserted
Port Status
Active
Error
1 2 3 4
ive Error Active Error Active Error Active Error Active Error
RX TX 2 RX TX 3 RX TX 4 RX TX 5 RX
Fiber cable
Figure 4-12 Cabling the 10BASE-FL Module
Receiver (Port 8)
5 6 7 8
Active Error Active Error Active Port Status
TX 6 RX TX 7 RX TX 8 RX
10BASE-FL
module

10BASE-2 (BNC) Module

This section contains information on the common
10BASE- 2 (BNC) configuration and how to cable
the 10BASE- 2 (BNC) media option.
10BASE-2 (BNC) Configuration
Figure 4-13 illustrates a sample 10BASE-2 (BNC)
configuration. Your configuration may have different
quantities and types of devices than pictured in this
example.
Figure 4-13 shows an Ethernet module with
10BASE-2 (BNC) connectors attached to a coaxial
cabling segment. In this example, network segments
are using cable that conforms to the IEEE 802.3
Type 10BASE-2 specification.
10BASE-2 cable
Figure 4-13 Sample Ethernet Configuration with the
10BASE-2 (BNC) Module
PCs