Table of Contents
Advertisement
THIS WATER HEATER IS FOR OUTDOOR INSTALLATION ONLY.
THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING.
This water heater is for connection to natural gas only.
Check the water heater is suitable for the gas type available.
(refer to the rating label on the water heater).
INSTALLATION STANDARDS
The water heater must be installed:
•
by a qualified person, and
•
in accordance with the installation instructions, and
•
in compliance with Plumbing Code of Australia (PCA), Standards
AS/NZS 3500.4 and AS/NZS 5601.1, and all local codes and regulatory
authority requirements.
Rheemglas 850 series
Warning: This water heater may deliver water at high temperature. Refer to
the Plumbing Code of Australia, local requirements and these installation
instructions to determine if additional delivery temperature control is required.
"Hot Water Delivery"
Refer to
RheemPlus 854 series
This water heater delivers water not exceeding 50°C in accordance with
AS 3498.
Warning: This water heater must only be installed in accordance with the
acceptable plumbing configurations specified in these installation instructions.
Failure to do so may result in conditions where delivery temperature control is
inadequate. Refer to
All packaging materials must be removed from the water heater prior to its
installation. This includes the removal of the cardboard base of the carton from
the underside of the water heater.
WATER HEATER APPLICATION
This water heater is designed for use in a single family domestic dwelling for the
purpose of heating potable water. Its use in an application other than this may
shorten its life.
If this water heater is to be used where an uninterrupted hot water supply is
necessary for the application or business, then there should be back-up
redundancy within the hot water system design. This should ensure the continuity
of hot water supply in the event that this water heater was to become inoperable
INSTALLATION
on page 31.
"Hot Water Delivery"
on page 31.
27
Advertisement
Table of Contents
