Table of Contents
Advertisement
Connecting to Another
Ethernet Hub
You can connect to another Ethernet hub to allow up to 25 users to access the
WAN. Instructions for adding another Ethernet hub to allow 10 users, a more
common scenario, is as follows.
Before You Begin
In addition to an external 10BASE-T Ethernet hub, you will need a 10BASE-T
Ethernet cable, which may have been provided with the additional hub. If the hub
to which you are connecting your LAN Modem does not have an MDI/X switch,
you must use a crossover cable.
1 Insert one end of the 10BASE-T Ethernet cable into one of the four LAN ports on
the back of the LAN Modem, as shown in Figure 13.
Figure 13 10BASE-T Hub-to-Hub Connection
2 Insert the opposite end of the cable into a 10 BASE-T Ethernet port on the other
Ethernet hub.
If you are connecting to an OfficeConnect Hub 8/TPO, insert the opposite end of
the Ethernet cable into port 8 and then set the MDI/X switch to MDI (that is,
pressed in). Make sure that the LED associated with that Ethernet port is lit. If it is
not, try changing the MDI/X switch setting.
Installing the 56K LAN Modem
31
Advertisement
Table of Contents
