Servicing The Air Filter; Changing The Engine Oil - Toro Recyler 20373 Operator's Manual

Servicing the Air Filter

Service Interval: Yearly
1. Press down on the latch tabs on top of the air-filter
cover (Figure 33).
g027782
1. Latch tabs
2. Paper air filter
2. Open the cover.
3. Remove the paper air filter and the foam pre-filter
(Figure 33).
4. Inspect the foam pre-filter, and replace it if it is
damaged or excessively dirty.
5. Inspect the paper air filter.
•
If the air filter is damaged or is wet with oil or fuel,
replace it.
•
If the air filter is dirty, tap it on a hard surface
several times or blow compressed air less than 207
kPa (30 psi) through the side of the filter that faces
the engine.
Note: Do not brush the dirt off the filter; brushing
forces dirt into the fibers.
6. Remove the dirt from the air-filter body and the cover
using a moist rag.
Important: Do not wipe dirt into the air duct.
7. Install the foam pre-filter and the paper air filter into
the air filter.
8. Install the cover.
Figure 33
3. Foam pre-filter

Changing the Engine Oil

Service Interval: After the first 5 hours
Yearly
Note: Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Engine oil capacity: 0.53 L (18 oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
g027782
1. Full
2. High
4. Tip the machine onto its side (so that the air filter is up)
to drain the used oil from the oil-fill tube
5. After draining out the used oil, return the machine to
the operating position.
18
17).
(Figure 34).
Figure 34
3. Low
(Figure
Figure 35
g186624
35).
g011724