Connecting Cables To Terminals - Kenwood KRC-V879R Instruction Manual

Connecting Cables to Terminals

Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
A–7 Red
A–8 Black
Speaker
Connector
B–1 Purple
B–2 Purple/Black
B–3 Gray
B–4 Gray/Black
B–5 White
B–6 White/Black
B–7 Green
B–8 Green/Black
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
FM/AM
antenna input
Functions
Rear left output (White)
Rear right output (Red)
Battery
Power Control
Dimmer
L
Ignition (ACC)
Earth (Ground)
R
REAR FRONT
Connection
Fuse(10A)
+
Rear Right ( )
Wiring harness
–
Rear Right ( )
(Accessory1)
+
Front Right ( )
–
Front Right ( )
+
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
–
Rear Left ( )
Battery cable (Yellow)
Ignition cable (Red)
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Antenna Cord (ISO)
Front left output (White)
Front right output (Red)
To KENWOOD disc changer/
DAB control input/
KPA-SD100/KPA-HD100/KPA-SS100
NOTE
To connect these leads, refer to the
relevant instruction manuals.
External amplifier control
cable
(Pink / Black)
TEL mute cable (Brown)
Power control/ Motor antenna
control cable (Blue/White)
8 6 4 2
NOTE
7 5 3 1
If no connections are
8 6 4 2
made, do not let the cable
7 5 3 1
come out from the tab.
— 41 —
To "EXT.AMP.CONT." terminal of the
EXT.CONT.
amplifier having the external amp
control function.
Connect to the terminal that is
TEL MUTE
grounded when either the telephone
rings or during conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
Connect either to the power control
P.CONT.OUT
terminal when using the optional
ANT.CONT.
power amplifier, or to the antenna
control terminal in the vehicle.