Table of Contents
Advertisement
• Be sure to use the supplied screws for installation.
Using screws longer than those supplied may destroy parts inside the unit causing it
to smoke. Using screws shorter than those supplied may cause the unit to come
looks from the installation bracket.
• If you are not going to install the unit using the supplied monitor stand, be sure to
use a commercially available monitor stand. (Mounting holes for such a stand are
located on the bottom of the monitor unit.)
2CAUTION
• If your car's ignition does not come with an ACC position, connect the ignition
cables to a power source that can be turned on and off with the ignition key. If you
connect the ignition wire to a power source that receives a constant voltage supply,
as with battery cables, the battery may die.
• If the fuse blows, first make sure that the cables have not caused a short circuit,
then replace the old fuse with one with the same rating.
• Do not let unconnected cables or terminals touch metal on the car or anything else
conducting electricity. To prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected cables.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on
the car are working properly.
• Insulate unconnected cables with vinyl tape or other similar material.
• Thoroughly wipe away oil and other dirt from the installation surface.
Please avoid installation on uneven surfaces.
7
Advertisement
Table of Contents
