Connection - Bosch AUTODOME IP starlight 5000i Installation Manual

AUTODOME IP starlight 5000i (pendant)
11

Connection

Warning!
Bosch's version of High PoE:
!
If supplying power to the camera by HPoE or a midspan device, you must install additional
surge protection.
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
!
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
Note: Consult the National Electrical Code (NEC) or other regional standards for cable
bundling requirements and limitations.
4
Label ID
AC24V
AC24V
EARTH
4
2
1
1
Figure 11.1: AUTODOME IP System Config
4
Bosch Security Systems
Connect the cable to the 24 VAC wires from the camera.
Description
24 VAC
24 VAC
Earth Ground
Connect the Ethernet cable to the RJ45 connector of the camera. The following figure
illustrates a typical system configuration.
3
2
1 AUTODOME camera
2 IP connection (Ethernet/CAT5/CAT6) (100 m maximum)
3 Network switch
4 Network device (computer with monitor, DVR/NVR, etc.)
If desired, connect the alarm and/or audio wires as identified in the following table.
Cable Wire Color
Red
Black
Yellow/Green
2
Installation Manual
Connection | en
4
4
2021-01 | 1.3 |
29