Attaching The Mounting Cap And The Camera - Bosch AUTODOME IP starlight 5000i Installation Manual

26 en | Installing a Roof Mount and Camera
4.
5.
6.
Figure 10.2: NDA-U-RMT
1
2
3
4
5
7.
8.
10.2

Attaching the Mounting Cap and the Camera

1.
2.
3.
2021-01 | 1.3 |
Attach the Parapet Wall Bracket using at least six (6) stainless steel fasteners, three (3)
on each side. (The bracket has eight (8) holes.) Be careful not to overtighten the
fasteners because it may strip the threads. If attaching the parapet mount to a flat roof,
attach the optional LTC 9230/01 Roof Mount Plate to the roof and then attach the
Parapet Wall Bracket to the Roof Mount Plate.
Insert the Parapet Pipe Arm into the mounting bracket until it bottoms in the bracket.
Remove the End Cap from the front of the arm. Feed the video, control, and power wires
up through the bottom of the pipe arm and out the front end.
End Cap with O-ring
Parapet Pipe Arm
1/4-20 SS Cap Screw
Down Pipe
10-24 SS Pan Head Screw
Fold back the video, control, and power wires at the front end of the arm and route them
down and out through the Down Pipe. Replace the End Cap.
Wrap at least five layers of Teflon tape around the Down Pipe threads.
To ensure a watertight seal, wrap Teflon tape four times around the threads at the end of
the wall mount.
Attach the mounting cap to the wall mount.
Secure the locking screw with the T15 Torx screwdriver.
Installation Manual
AUTODOME IP starlight 5000i (pendant)
Bosch Security Systems