Table of Contents
Advertisement
To see the time display :
Press the CLOCK button.
•
The time display will appear for about 5 seconds.
Note :
• The clock display will flash on and off at the push
of the CLOCK button when the AC power sup-
ply is restored after a power failure occurs or
after the AC power cord is disconnected. If this
happens, follow the procedure below to change
the clock time.
SETTING THE CHANNEL SPAN
The span between radio channels has been set to the one that prevails in the area to which the system is
shipped. However, if the current channel span setting does not match the setting in the area where the
system is to be used, for instance when you move from area 1 or area 2 shown in the following table or
vice versa, proper reception of AM/FM broadcasts cannot be expected. In this case, change the channel
span setting in accordance with your area by refering to the following table.
Area
1 USA, Canada and Latin
America Countries
2 Other countries
1
Press the
the standby mode.
2
Set the SPAN SELECTOR switch to "50/9" for
9 kHz AM interval (50 kHz FM interval), and "100/
10" for 10 kHz AM interval (100 kHz FM inter-
val).
3
Whilst pressing down the 7 STOP button and
the SOUND MODE button, hold down the
ON/STANDBY button for at least 1 second.
•
"CLEAR AL" will appear.
12
EN
CHANNEL
SPAN freq.
FM : 100 kHz
AM :
FM : 50 kHz
AM :
ON/STANDBY button to enter
To change the clock time :
1 Press the CLOCK button.
2 Within 5 seconds, press the MEMORY/SET but-
ton.
3 Perform steps
To change the time display mode :
1 Perform steps
TING THE MICROCOMPUTER", on page 37.
2 Perform step
(Except for the Europe and U.K.)
10 kHz
9 kHz
Caution :
•
The operation explained above will erase all data
stored in memory including clock and timer set-
tings, and tuner and CD presets.
6
9
-
on page 11 .
1
2
-
in the section "RESET-
1
9
-
on page 11.
Hide quick links:
Advertisement
Table of Contents
