Setting The Clock - Kenwood XD-855 Instruction Manual

SETTING THE CLOCK

2
3
4
5
6
7
8
9
In this example, the clock is set for the 24 hours
(0:00) system.
1
Press the ON/STANDBY button to enter
the standby mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET
button.
4
Press the TUNING/TIME (%UP or fiDOWN) but-
ton to select the time display mode.
"0:00" : The 24-hours display will appear.
(0:00 - 23:59)
"AM 0:00" : The 12-hours display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00" : The 12-hours display will appear.
(AM 12:00 - PM 11:59)
•
Note that this can only be set when the unit is
first installed or it has been reset (see page 37
- RESETTING THE MICROCOMPUTER).
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME (%UP or fiDOWN)
button to adjust the hour.
Press the TUNING/TIME (%UP or fiDOWN)
•
button once to advance the time by 1 hour.
Hold it down to advance continuously.
•
When the 12-hours display is selected, "AM"
will change automatically to "PM"
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME (%UP or fiDOWN)
button to adjust the minutes.
Press the TUNING/TIME (%UP or fiDOWN)
•
button once to advance the time by 1 minute.
Hold it down to change the time in 5 minutes
intervals.
•
The hour setting will not advance even if min-
utes advance from "59" to "00".
9
Press the MEMORY/SET button.
•
The clock starts operating from "0" second.
(Second are not displayed.)
And then the clock display will disappear after
a few seconds.
11 EN