Before Applying Power; Safety Precautions - Kenwood XD-855 Instruction Manual

BEFORE APPLYING POWER

Caution : Read this page carefully to ensure safe operation.
Units are designed for operation as follows.
Europe and U.K. ........................... AC 230 V only
China and Russia .......................... AC 220 V only
For the United Kingdom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement,
use only a 3-Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing
the fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment.
If the plug fitted is not suitable for the power points
in your home or the cable is too short to reach a
power point, then obtain an appropriate safety ap-
proved extension lead or adapter, or consult your
dealer.
If nonetheless the mains plug is cut off, remove
the fuse and dispose of the plug immediately, to
avoid a possible shock hazard by inadvertent con-
nection to the mains supply.
IMPORTANT:The wires in the mains lead are coloured
in accordance with the following code:
Blue : Neutral
Brown : Live
Do not connect those leads to the earth terminal of a
three-pin plug.

SAFETY PRECAUTIONS

WARNING :
RISK OF ELECTRIC SHOCK
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-
TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN
THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK
OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER
TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS
IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
The marking of products using lasers
(Except for some areas)
LASER PRODUCT
The marking is located on the rear panel and
says this product has been classified as Class
1. It means that there is no danger of hazard-
ous radiation outside the product
2 EN
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
DO NOT OPEN
CLASS 1
Other countries .......... AC 110 / 127 / 220 / 230 -
* AC voltage selection
The AC voltage selector switches on the rear
panel are set to the voltage that prevails in the
area to which the unit is shipped. Before con-
necting the power cord to your AC outlet, make
sure that the setting positions of these switches
match your line voltage. If not, they must be set
to your voltage in accordance with the following
direction.
AC voltage selector switches
Turn the selector to match your line voltage
with a small screwdriver or other pointed tool.
(110V, 127V, 220V or 230V - 240V AC)
Note:
Our warranty does not cover damage
caused by excessive line voltage due to improper
setting of the AC voltage selector switch.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
240 V switchable*