Advertisement
Step
Check Item
5
Replace
EM2100
FLOW
License
Dongle
6
Replace
EM2100
Legacy
License
Dongle
7
Place cover
back on and
power up unit
8
Enable
entitlement
6
Remove old EM2100 FLOW License Dongle and insert new dongle.
Remove old EM2100 Legacy License Dongle and insert new dongle.
Replace the top panel, install the retaining screws and return the EM2100 to the rack. Plug in
power supply cable. Set power switch on back panel to the On position and then set power
switch on front panel to the On position.
If replacing EM2100 FLOW License Dongle, follow the procedure in the FLOW CORE
User's Guide section 7.6(Licensing Tab) for enabling entitlement. If only the EM2100 Legacy
License Dongle was replaced no further steps are required.
P/N 18982-008 Rev A
Task to be Performed
FLOW Dongle
Legacy Dongle
Check
□
□
□
□
FLOW Service Guide
Advertisement
