GETTING STARTED
BATTERY INSTALLATION
1. Make sure the dino is turned OFF.
2. Locate the battery cover on the bottom of the panel.
3. Use a screwdriver to open the cover.
4. Install 2 new AA size (LR6/AM-3) batteries following
the diagram inside the battery box. (The use of new,
alkaline batteries is recommended for maximum
performance).
5. Replace the battery cover and tighten the screw to
secure.
Note: If there is no response when Boost is
switched ON, please install brand new
batteries and try switching Boost ON again.
BATTERY NOTICE
•
Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
•
Use only batteries of the same or equivalent type as
recommended.
•
Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
•
Do not use damaged batteries.
•
Insert batteries with the correct polarity.
•
Do not short-circuit the battery terminals.
•
Remove exhausted batteries from the toy.
•
Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
•
Do not charge non-rechargeable batteries.
•
Remove rechargeable batteries from the toy before charging (if
removable).
•
Rechargeable batteries are only to be charged under adult
supervision.
4