Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for VTech Switch & Go Dinos Dino Launcher 2-in-1
Summary of Contents for VTech Switch & Go Dinos Dino Launcher 2-in-1
- Page 1 Instruction Manual...
- Page 3 INTRODUCTION Switch into fun with Switch & Go Dinos Dino Launcher 2-In-1! ® Combine these two daring prehistoric creatures to form a mega car! Launch the two fireball projectiles, then launch the race car and watch it switch into a super Spinosaurus as it rockets forward. Fireball Button Launch Button Auto-Switch Button...
-
Page 4: Included In The Package
INCLUDED IN THE PACKAGE One Switch & Go Dinos Dino Launcher 2-in-1 • ® • One Quick Start Guide WARNING All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety. - Page 5 INSTRUCTIONS Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover located on the bottom of the unit, use a screwdriver to loosen the screw, and then open the battery cover. 3. Remove the old battery by pulling up on one end of the battery.
- Page 6 IMPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used.
- Page 7 In the UK, give this toy a second life by disposing of it at a small electricals collection point* so all of its materials can be recycled. Learn more at: www.vtech.co.uk/recycle www.vtech.com.au/sustainability * Visit www.recyclenow.com to see a list of collection points near you.
-
Page 8: Product Features
PRODUCT FEATURES 1. Off/Low/High Volume Switch To turn the unit On or to adjust the volume, slide the Off/Low/High Volume Switch to the Low High Volume position. To turn the unit Off, slide the switch to the Off position. 2. Talk Button Press the Talk Button to hear fun phrases and cool dinosaur sounds with light effects in Dino mode, or to... - Page 9 5. LED Lights The LED Lights flash along with the sounds in all modes. 6 Fireball Button Press the Fireball Button to launch a fireball projectile. 7. Automatic Shut-Off To preserve battery life, the unit will automatically shut off after approximately 20 seconds without input.
- Page 10 HOW TO SWITCH Switching from Spinosaurus mode to Vehicle mode 1. Begin in Spinosaurus mode. 2. Flip the tail towards the head of the dino. 3. Push the back wheels up. 4. Flip the Dino’s mouth up and then flip the legs towards the head of the dino.
- Page 11 Switching from Vehicle mode to Spinosaurus mode Press the Auto-Switch Button to automatically switch from Vehicle to Spinosaurus mode. Switching from Pterodactyl mode to Launcher mode 1. Begin in Pterodactyl mode. 2. Flip the head down towards the Pterodactyl’s body. 3.
- Page 12 5. The Pterodactyl is now in Launcher mode. Combination Insert the vehicle into the launcher to form the Mega Car. Press the Launch Button to release the vehicle and auto-switch into a Spinosaurus.
-
Page 13: Care And Maintenance
CARE & MAINTENANCE 1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat source. 3. Remove the batteries when the unit is not in use for an extended period of time. -
Page 14: Consumer Services
Australian Customers: VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/ consumerguarantees for further information. - Page 15 Visit our website for more information about our products, downloads, resources and more. www.vtech.co.uk www.vtech.com.au TM & © 2023 VTech Holdings Limited. All rights reserved. IM-549303-001 Version:0...