Table of Contents
Advertisement
GETTING STARTED
This product is in Try-Me ( ) mode in the packaging. Move the
Power Switch to the ON (
powers down during play, please install a new set of batteries.
INSTRUCTIONS
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove old batteries.
4. Install 4 new AA (LR6/AM-3) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
•
Only batteries of the same or equivalent type as recommended
are to be used.
•
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
) position to exit Try-Me mode. If the unit
of
children.
4
Advertisement
Table of Contents
