Page 3
INTRODUCTION Switch into fun with the Switch & Go Dinos ® Smash the T-Rex. Switch this ferocious T-Rex into an agile Drift Car and back in just a few simple steps. Ready to smash and crash? Here we go! Game Button Crash Trigger Off / Low / High Volume Switch...
INCLUDED IN THIS PACKAGE • Switch & Go Dinos ® Smash the T-Rex • Parent’s Guide WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy and should be discarded for your child’s safety.
GETTING STARTED Battery Removal and Installation 1. Make sure the unit is turned Off. 2. Find the battery cover on the back of the unit, use a screwdriver to loosen the screw and then open the battery box. 3. Remove old batteries by pulling up on one end of each battery.
IMPORTANT: BATTERY INFORMATION • Insert batteries with the correct polarity (+ and -). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. • Only batteries of the same or equivalent type as recommended are to be used.
Page 7
The solid bar indicates that the product was placed on the market after 13th August, 2005. Help protect the environment by disposing of your product or batteries responsibly. VTech ® cares for the planet. Care for the environment and give your toy a second life by disposing of it at a small electricals collection point so all its materials can be recycled.
PRODUCT FEATURES 1. Off / Low / High Volume Switch To turn the unit On or adjust the volume, slide the switch to the Low or High Volume position. To turn the unit Off, slide the switch to the Off position.
5. Automatic Shut-Off To preserve battery life, Smash the T-Rex will automatically turn off after approximately 40 seconds without input. Smash the T-Rex can be woken up again by pressing the Game Button, hitting the Crash Trigger, or by switching between Dino and Vehicle mode.
Page 10
4. Flip the rear tyres back as 3. Pull the legs up and illustrated. toward the dino’s body as illustrated. 5. Move the windscreen 6. Vehicle mode. forward as illustrated. Note: To switch from Vehicle mode to Dino mode, follow the above steps in reverse order.
CARE & MAINTENANCE 1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat sources. 3. Remove the batteries if the unit will not be in use for an extended period of time.
Australian Customers: VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED – CONSUMER GUARANTEES Under the Australian Consumer Law, a number of consumer guarantees apply to goods and services supplied by VTech Electronics (Australia) Pty Limited. Please refer to vtech.com.au/ consumerguarantees for further information.