Manually Adding And Deleting Channels In The Channel Memory - Toshiba 62HM196 User Manual

HM196_EN.book Page 27 Tuesday, May 30, 2006 2:18 PM
Manually adding and deleting channels
in the channel memory
After automatically programming channels into the channel
memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
Press Y and open the Setup menu.
1
Highlight Installation and press T.
2
3
(A new set of Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Channel Add/Delete, and then press T.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate ENTER
4
The illustration below left shows channels programmed
for the ANT 1 antenna input. To view the list of channels
programmed for the ANT 2 or Cable box antenna input,
press Bb to highlight ANT 2 and press T.
Channel Add/Delete
2 Analog ANT 1
2 - 1 Digital ANT 2
2 - 2 Digital
Analog
3
4 Analog
5 Analog
Analog
6
7 Analog Reset
7 - 1 Digital Cancel
Analog Done
8
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number you
want to add, and then press T to check the box.
To manually add digital subchannels on a physical
channel:
Use the Channel Numbers and the Dash (=) on the remote
control to enter the channel number (for example, 56–1).
If the channel is found, the number will be added to the list and
the box will be checked.
If the channel is not found, a message will appear.
Chapter 4: Setting up your TV
Select CH RTN Back EXIT Exit
Channel Add/Delete
Analog ANT 1
1
ANT 2
2 Analog
3 Analog
4 Analog
5 Analog
Analog
6
7 Analog
8 Analog Reset
9 Analog Cancel
Analog
10 Done
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press T to uncheck the box.
To save your new settings:
Highlight Done and press T.
To revert to your original settings:
Highlight Cancel and press T before saving.
To remove all channels from the channel memory:
Highlight Reset and press T, and then highlight Done and
press T.
Channel Add/Delete
2
2 - 1
2 - 2
3
4
5
6
7
7 - 1
8
Note: This action applies to the current antenna input only. To
delete/add channels on the other input, highlight the input you
want (ANT1, or ANT 2) and press T.
Analog ANT 1
Digital ANT 2
Digital
Analog
Analog
Digital
Analog
Analog Reset
Digital Cancel
Analog Done
27
HM196 (E/F) Web 213:276