Unlocking Programs Temporarily; Using The Input Lock Feature; Hm116 (E/F) Web 213:276 - Toshiba 62HM116 Operating Manual

HM116_EN.book Page 50 Monday, June 19, 2006 7:30 PM
To unblock all blocked channels at once:
Highlight Allow All in step 6 on the previous page, and then
highlight Done and press T.
Channels Block
1
2
3
4
5
6
7
8
9
10

Unlocking programs temporarily

If you try to tune the TV to a program that exceeds the rating
limits you set, the TV will enter program lock mode and the
following message will appear:
This program exceeds the rating limit you set.
Push 'mute' to enter PIN.
You can either temporarily unlock the program or select an
unlocked program to watch.
To temporarily unlock the program:
1
Press W.
2
Enter your four-digit PIN code and press T. If the correct
code is entered, the program lock mode is released and the
normal picture appears. All locking is disabled until the
TV is turned off, and will be enabled when the TV is
turned on again.
Locks
Enter PIN code to temporaily un-block.
* * * *
Cancel
50
Chapter 5: Using the TV's features

Using the input lock feature

You can use the Input Lock feature to lock the video inputs
(VIDEO 1, VIDEO 2, ColorStream HD-1, ColorStream
HD-2, HDMI 1, and HDMI 2) and channels 3 and 4. You will
not be able to view the input sources or channels until you
ANT 1
unlock the inputs.
ANT 2
To lock/unlock the video inputs:
1
Allow All
Block All
2
Cancel
Done
3
4
5
Active
Done
Press Y and highlight the Locks menu icon.
Press b to display the PIN code entering screen.
Enter your four-digit PIN code and press T.
Press b to highlight Input Lock and press c.
Locks
Enable Rating Blocking
Off Off
Edit Rating Limits
Video
Channels Block Video +
Input Lock
Off
Front Panel Lock Off
Game Timer
Off
New PIN Code
Navigate ENTER Select MENU Back
Press B or b to select the desired level of video input
locking (Video, Video+, or Off, as described below),
and then press T.
Video: Locks VIDEO 1, VIDEO 2, ColorStream HD1/
HD2, HDMI 1/HDMI 2.
Video+: Locks VIDEO 1, VIDEO 2, ColorStream HD1/
HD2, HDMI 1/HDMI 2, and channels 3 and 4.
Select Video+ if you play video tapes via an ANT input.
•
™
When a CableCARD is inserted, Video+ will not lock
•
channels 3 and 4.
Off: Unlocks all video inputs and channels 3 and 4.
EXIT Exit

HM116 (E/F) Web 213:276