Connecting A Dvd Player With Colorstream; A Satellite Receiver - Toshiba Regza 40XV645U Owner's Manual

Connecting a DVD player with ColorStream

a VCR, and a satellite receiver
Your TV has two sets of ColorStream
Y P
P
B R
COMPONENT VIDEO VIDEO
S-VIDEO
OUT OUT
DVD player with component video
From satellite dish
Y P P
B R
COMPONENT VIDEO VIDEO
Satellite
S-VIDEO
OUT
IN
OUT
Satellite receiver with component video
You will need:
•coaxial cables
•standard A/V cables
– For better picture performance, if your VCR has S-
video, use an S-video cable (plus the audio cables)
instead of the standard video cable. Do not connect
both types of video cable to VIDEO 1 at the same
time or the picture performance will be
unacceptable.
– If you have a mono VCR, connect L/MONO on the TV
to your VCR's audio out terminal using the white
audio cable only.
•standard audio cables
•component video cables
– You can connect the component video cables (plus
audio cables) from the DVD player or satellite
receiver to either set of ColorStream terminals on the
TV (HD1 or HD2). The ColorStream HD1 and HD2
terminals can be used to display Progressive (480p,
720p, 1080p) and Interlaced (480i, 1080i). Please
check the Owner's Manual of the DVD player or
satellite receiver in order to determine the best output
signal available (1080p 24Hz/30Hz/50Hz/25Hz are
not supported).
– If your DVD player or satellite receiver does not have
component video, connect a standard A/V cable to
VIDEO 2 on the side panel. If your DVD player has
HDMI video, see page 15.
To view antenna or Cable channels:
Select the ANT/CABLE video input source on the TV.*
14
Chapter 2: Connecting your TV Chapter 2: Connecting your TV
®
(component video) inputs.
TV upper back panel
AUDIO
OUT
L
R
AUDIO
OUT
L
R
TV lower back panel
®
(component video),
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD1
video input source on the TV.*
To view satellite programs using the component video
connections:
Turn on the satellite receiver. Select the ColorStream
HD2 video input source on the TV.*
To view the VCR or view and record antenna channels:
Turn ON the VCR. Tune the VCR to the channel you
want to watch. Select the VIDEO 1 video input source
on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to
record. Select the ColorStream HD1 video input
source on the TV* to view the DVD.
* To select the video input source, press INPUT on the
remote control (- page 32). To program the TV remote
control to operate other devices, see Chapter 3.
The unauthorized recording, use, distribution, or
revision of television programs, videotapes, DVDs,
and other materials is prohibited under the Copyright
Laws of the United States and other countries, and
may subject you to civil and criminal liability.
From antenna
Stereo VCR
VIDEO AUDIO
L R
IN IN from ANT
CH 3
CH 4
OUT
OUT to TV
L R