Setting The Hdmi ™ Audio Mode; Viewing The Digital Signal Meter - Toshiba TheaterWide 26HL66 User Manual

To clear the Favorite Channel lists:
1
Press Y and open the Preferences menu.
2
Highlight Favorite Channels and press T.
3
Highlight Edit and press T.
4
Highlight Reset and press T. All channels in the
Favorite Channels list will be deleted (unchecked).
5
Highlight Done and press T.
Edit Favorite Channels
2
2 - 1
2 - 2
4 - 1
5
17 - 1
17 - 2
28 - 1
28 - 2
28 - 3
To tune your favorite channels (antenna channels
only):
Press M / m.
To tune your favorite antenna channels using the
Favorite Channel list:
1
Press = to display the Favorite Channel list.
2
Press the corresponding number button (1-9) to select
your desired channel.
1 CH 4-1
2
CH 4-2
3 CH 9
4 CH 10
5 CH 12
6 CH 17
7 CH 19
8 - - -
9 - - -
Chapter 4: Setting up your TV
ANT 1
Reset
Cancel
Done
Setting the HDMI
To set the HDMI audio mode:
1
Press Y and open the Setup menu.
2
Highlight HDMI Audio and press c.
3
Press b or B to select the HDMI audio mode (Auto,
Digital, or Analog) and press T. (Auto is the
recommended mode.) See "Connecting an HDMI or DVI
device to the HDMI input" in the Installation Guide.
Setup
Installation
Sleep Timer
PC Settings
PC Audio
HDMI Audio
Power-On Mode
Navigate Select
ENTER
Note: Because the PC IN and HDMI (DVI) IN inputs share the
same set of analog audio inputs, the PC Audio menu setting
influences the HDMI Audio menu setting. If PC Audio is set to
"No," the HDMI Audio setting changes to "Auto." If PC Audio
is set to "Yes," the HDMI Audio setting is set to "Digital" and is
grayed out in the menu. (Also see item 3 on page 6 and
"Setting the PC Audio mode" on page 38.)

Viewing the digital signal meter

You can view the digital signal meter in the ANT 1 digital TV
input source only.
To view the digital signal meter:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T.
A new set of Installation menu icons appears, as shown in
step 3 below.
3
Open the Terrestrial menu, highlight Signal Meter,
and press T.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate ENTER Select
™ audio mode
Auto
Digital
Analog
No
Auto
Power-Saving
Back Exit
CH RTN EXIT
CH RTN Back EXIT Exit
(continued)
19