Using The Remote Control To Operate Your Other Devices - Toshiba TheaterWide 26HL66 User Manual

Using the remote control to operate
your other devices
If you have a non-Toshiba device or a Toshiba device that the
remote control is not preprogrammed to operate, you must first
program the remote control to recognize the device (if you
have not already done so) (- pages 11–13).
To use your TV remote control to operate a:
Cable converter box or satellite receiver, set the MODE
•
SELECT switch to CABLE/SAT.
DVD player or HTIB, set the MODE SELECT switch to
•
DVD.
VCR, set the MODE SELECT switch to VCR.
•
Note: Even after the TV remote control is programmed, it may
not operate certain features on your other device. If this
happens and you wish to use those features, you will need to
use the device's original remote control.
Point the remote control
directly at the device.
Chapter 2: Using the remote control
1 POWER Turns the selected device on and off.
2 Channel Numbers (0-9) Press to directly access
channels (as opposed to < ,).
3 +10 Press to directly access DVD chapters higher than 10.
CH Bb For channels programmed into the channel
4
memory (page 17):
B selects the next higher channel.
b selects the next lower channel.
5 GUIDE Displays the channel guide.
6 INFO Displays TV status information.
BbC c Navigate DVD menus (may not work on some
7
DVD players).
8 ENTER Required by some satellite receivers and DVD
players to activate certain functions.
9 DVD CLEAR Resets the title and chapter number.
10 PLAY Begins playback of a tape or DVD.
11 PAUSE Press during play or record mode to pause the
picture; press again to restart.
12 STOP Stops the tape or DVD.
13 SKIP z Skips forward to locate later DVD chapters.
14 FF Fast-forwards the tape or DVD. (Press during PLAY
mode to view the picture moving rapidly forward.)
15 SKIP Z Skips back to beginning of current DVD
chapter, or locates previous chapters.
16 REW Rewinds/reverses the tape or DVD. (Press during
play mode to view the picture moving rapidly backward.)
17 TV/VCR To view one program while recording another,
select "TV".
18 REC Starts tape recording.
19 TOP MENU Accesses a DVD's top menu.
20 SET UP Accesses a DVD's setup menu.
21 MODE SELECT switch Set to "TV" to control the TV;
"CABLE/SAT" to control a cable converter box or
satellite receiver; "DVD" to control a DVD player or
HTIB; "VCR" to control a VCR.
9