Loading Paper - Royal ER-145 Manual

The ER 145 register uses 2' 4 dual carbonless paper to produce both a customer
receipt (outside) and a journal record (inside) The register will also accept
standard 2' 4 calculator paper for a single tape record
1 Plug in your cash register
2 Cut or tear the end of the paper roll evenly for a straight even edge for
proper feeding through the prmthead
3 Place paper roll in paper holder so that the paper will feed from the bottom of
the roll (See Fig 1 )
4 Insert both ends (if using dual tape) or the end of a single paper tape into the
paper slot (See Fig 2 )
5 Depress the paper [FEED] key until the paper catches and advances
through the printer
6 If paper does not feed through the printer make sure the paper is entered
properly inspect the end of paper tape
7 To insert the journal winder it is not necessary to remove the journal winder
spindle Simply advance the tape approximately 1012 inches by using the
[FEED] key Then slide the inside pressure sensitive tape under one of the
forks that extends on either side of the journal winder Press the [FEED]
again and hold it down The journal tape will then automatically secure itself
8 Pass the outside plain tape through the receipt window of the journal
printer cover
9 Replace journal printer cover
NOTE
mechanism found with inexpensive paper rolls Replace with ROYAL brand carbonless two ply paper order #013130 or standard bond
quality calculator paper ROYAL order #013129

LOADING PAPER