Mitsubishi Electric 700 Series Instruction Manual page 194

(2) Clearing procedure
POINT
Set "1" in Er.CL Fault history clear to clear the faults history.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Press to choose the parameter setting mode.
3.
Turn until (faults history clear)
appears.
4.
Press to read the currently set value. "
value) appears.
5.
Turn to change it to the set value "
6.
Press to set.
Turn
Press
Press
Parameters referred to
Pr. 77 Parameter write selection
" (initial
".
to read another parameter.
to show the setting again.
twice to show the next parameter.
Refer to page 166
Check and clear of the faults history
PRM indicator is lit.
(The parameter number read previously appears.)
Flicker...Faults history clear complete!!
Display
189
5