V/F pattern
REMARKS
When torque is continuously regenerated as vertical lift load, it is effective to set the rated voltage in Pr. 19 Base frequency voltage
to prevent trip due to current at regeneration.
In addition, when the RT signal is ON, the other second functions are also valid.
NOTE
Load pattern selection does not function under Advanced magnetic flux vector control and General-purpose
magnetic flux vector control.
Parameters referred to
Pr. 0, Pr. 46 (Torque boost)
Pr. 3 Base frequency
General-purpose magnetic flux vector control
Advanced magnetic flux vector control
110
Refer to page 94
Refer to page 107
Refer to page 98
Refer to page 95