Table of Contents
Advertisement
Do not try to remove a memory module with the computer
turned on. You may damage the computer, the module, or
both.
Do not remove the memory module while the computer
is in Stand By mode. The computer could hang up the
next time you turn it on and data in memory will be lost.
In either of the above cases, the Stand By configuration
will not be saved.
The following message appears when you turn on the
power from Stand By mode:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
4
If the computer is on, click Start, Turn off computer.
The Turn off computer window appears.
5
Click Turn Off.
The operating system turns off the computer.
6
Unplug and remove any cables connected to the
computer, including the AC adapter cord/cable.
7
Remove the battery (see
computer" on page
8
Close the display panel and turn the computer upside
down to locate the expansion memory slot cover to the
memory slot.
Getting Started
Adding memory (optional)
"Removing the battery from the
125).
59
Advertisement
Table of Contents
