Adjusting The Mowing Speed - Toro Greensmaster TriFlex 3320 Operator's Manual

Figure 41
1. Pedal stop
1. Put the functional-control lever in the T
position and loosen the locknut securing the
pedal stop to the floor plate
2. Tighten the pedal stop until it does not contact
the traction pedal.
3. Continue applying a light load on the transport
pedal and adjust the pedal stop so it contacts
the pedal rod and tighten the nuts.
Important:
Ensure that the tension on the
cable is not excessive or you will reduce the
cable life.
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2. Loosen the pedal stop until you obtain the
desired transport speed.
3. Tighten the locknut securing the pedal stop.
g015494
RANSPORT
(Figure 41).
41
Adjusting the Mowing
Speed
The mow speed is set to 3.8 mph at the factory.
You can adjust the forward moving speed from 0 to 8
km/h (0 to 5 mph).
1. Loosen the jam nut on the trunnion bolt
42).
2. Loosen the nut securing the lock and mow
brackets on the pedal pivot.
Figure 42
1. Jam nut
2. Nut
3. Rotate the trunnion bolt clockwise to reduce the
mowing speed and counterclockwise to increase
the mowing speed.
4. Tighten the jam nut on the trunnion bolt and the
nut on the pedal pivot to lock the adjustment
(Figure 42). Check the adjustment and adjust
as required.
(Figure
g014625
3. Trunnion bolt