Table of Contents
Advertisement
Getting to Know the Windows ® XP Media Center
If you have a cable TV set-top box, satellite, or other set-top
box that controls your TV signal, connect the remote sensor
control cable to the remote sensor and position the end of it
over the remote receiver on your cable box.
1
Plug the remote sensor cable into a USB connector on the
back of the computer.
2
Position the remote sensor so you can easily point at it
with the remote control.
3
As necessary, plug the remote sensor control cable into
the back of the remote sensor. Position the end of the
control cable over the remote IR receiver window on your
cable TV set-top box. Remove the paper from the
backing tape on the end of the cable and press it into
place over the IR window on your box.
Connecting the TV Signal Source
Connect the signal source for your TV using a TV (IN)
coaxial connector as follows:
1
Plug the connector of a coaxial cable from your TV cable
(wall or set-top box) into the TV IN connector on the
Select bay TV tuner on the computer, and carefully
tighten it.
Location of the TV IN
2
Turn on the TV and select the TV IN video source (refer
to your TV set reference manual as necessary).
Media Center Setup
TV IN
167
Advertisement
Table of Contents
