Table of Contents
Advertisement
CAUTION: Avoid touching the connectors on the memory module
or on the computer. Grease or dust on the connectors may cause
memory access problems.
4
Complete the procedure by following steps 10 through 12
in
Checking total memory
When you add or remove memory, you can check that the
computer has recognized the change. To do this:
1
Click Start, Control Panel
2
Click Performance and Maintenance.
3
Click System.
4
The General tab view automatically appears and shows
the recognized memory.
5
If the computer does not recognize the memory
configuration, turn off the computer, remove the memory
slot cover, and make sure the memory module is seated
properly, as described in steps 8 and 9 of
additional memory (optional)" on page
Connecting a mouse
You may want to use a mouse instead of the TouchPad, the
computer's built-in pointing device.
To connect a mouse, plug the mouse cable into one of the
computer's USB ports. You can connect it after you turn on
the computer.
The operating system automatically detects the mouse. The
mouse and TouchPad can be used at the same time.
"Installing additional memory (optional)" on page
Getting Started
Connecting a mouse
46.
51
46.
"Installing
Advertisement
Table of Contents
