Table of Contents
Advertisement
50
Getting Started
Installing additional memory (optional)
1
Follow steps 1 through 6 in
memory (optional)" on page
CAUTIONS: Do not try to remove a memory module with the
computer turned on. You can damage the computer and the
device.
Do not remove the memory module while the computer is in
Standby mode. The computer could hang up the next time you
turn it on and data in memory will be lost. In either of the above
cases, the Standby configuration will not be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for five
seconds, then turn the power on again.
2
Push the latches to the outside to release the module. A
spring will force one end of the module up.
Removing the memory module
3
Gently pull the module out.
"Installing additional
46.
Advertisement
Table of Contents
