Roll Groover Assembly Instructions; Installing 918-1 Roll Groover On 300 Power Drive; Installing 918-2 Roll Groover On 1822 Threading Machine - RIDGID 918 Series Operator's Manual

Installing the 918-1 Roll Groover on the
300 Power Drive
Figure 2 – Installing on 300 Power Drive
1. Remove carriage or other attachments from the 300
Power Drive.
2. Fully open front chuck of power drive.
3. Slide the base assembly onto the support arms of the
300 Power Drive. (Figure 2)
4. Align the notched flats of the drive shaft with the
jaws on the 300 Power Drive chuck.
5. Close and tighten the front chuck.
Installing the 918-2 Roll Groover on the
1822 Threading Machine
Sub-Assembly
1. Position 918 Roll Groover on the mounting base as
shown in Figure 3 .
2. Install and tighten the (2)
connect 918 to mounting base.
3. Position hydraulic pump and securely bolt in place
" x
with (4) 1 /
4
4. Attach drive bar adapter to roll groover by tightening
two (2) set screws.
1.800.561.8187
918 Roll Groover
" x 1 " hex bolts which
1 / 1 /
2 4
" hex bolts.
3 /
4
www.
Drive Bar
Hydraulic
Pump
Figure 3 – 918 Heavy Duty Roll Groover on 1822 Mounting
Installing on 1822 Threading Machine with 1406
Stand
1. Position carriage towards front chuck and swing tools
to the rear position. Remove carriage stop pin at the
end of rail.
CAUTION
prevent accidental contact.
2. Front chuck must be open. Position 918-2 so that the
base slides onto the support rails and drive bar feeds
into open chuck.
3. Place carriage stop pin in support rail hole.
4. Install support legs into socket holes on the base.
(Figure 4) and tighten locking bolts.
WARNING
jaws. All bolts must be tight and the drive bar must be
securely held in chuck when closed.
Installing on 1822 Threading Machine with 100,
150, or 200 Stands
1. Position carriage towards front chuck and swing tools
to the rear position. Remove carriage stop pin at the
end of the rail.
CAUTION
prevent accidental contact.
2. Front chuck must be open. Position 918-2 so that the
base slides onto the support rails and drive bar feeds
into open chuck.
3. Replace carriage stop pin in support rail hole.
Ridge Tool Company
.com
" x "
1 / 3 /
4 4
Bolts (4)
Base
Position reamer inside the die head to
Drive bar must be centered in front chuck
Position reamer inside the die head to
information@itm.com
Mounting
Base
" x 1 "
1 / 1 /
2 4
Bolts (2)
5