Disabling (Enabling) Auto Tray Switching - Sharp MX-M232D Operation Manual

BEFORE USING THE MACHINE
7
Press the [OK] key.
A message asking you to
OK
confirm the new paper size
setting will appear.

DISABLING (ENABLING) AUTO TRAY SWITCHING

When auto tray switching is enabled and paper runs out during copying or printing, the job will continue using paper
from a different tray if that tray has the same size of paper in the same orientation. (This function does not operate
when using the bypass tray or when a fax is being printed.) This function has been enabled at the factory. If you
prefer to disable the function, follow the steps below.
1
Press the [SPECIAL FUNCTION] key.
ON LINE
DATA
SPECIAL
FUNCTION
LINE
COPY EXPOSURE PAPER SE
DATA
SCAN COLOUR MODE RESOLUT
The special function
screen will appear.
The above screen appears in copy mode.
2
Select "PAPER SIZE SET" with the [ ]
or [ ] key.
PQ
ED COPY
LEX SCAN
LEX SCAN
ACC
3
Press the [OK] key.
GHI
BACK
OK
PQRS
PY
AN
The paper size setting
screen will appear.
27
SPECIAL FUNCTION
ID CARD COPY
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
SPECIAL FUNCTION
ID CARD COPY
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
PAPER SIZE SET
A4 A3
A3 B4
A4
A4R
8
Press the [OK] key.
The selected paper size will be
OK
stored and the display will
return to the base screen.
Affix the paper size label for the paper size
Note
selected in step 6 to the label position on the
right end of the tray.
4
Press the [ ] key repeatedly until
"AUTO TRAY SWITCHING" appears.
Move the cursor to the lowest tray and then press the
[ ] key again. The above screen will appear.
5
Press the [OK] key.
OK
When a checkmark does not appear in the checkbox,
the auto tray switching function will not operate.
6
Press the [ ] key.
You will return to the
paper size setting screen.
To re-enable auto tray switching, press the [OK] key in
the screen of step 5 so that a checkmark appears.
PAPER SIZE SET
AUTO TRAY
SWITCHING
PAPER SIZE SET
AUTO TRAY
SWITCHING
PAPER SIZE SET
A4 A3
A3 B4
A4
A4R