Table of Contents
Advertisement
ADJUSTING THE BELT TRACKING
WARNING: ALWAYS WEAR EYE PROTECTION WHEN ADJSUTING OR
OPERATING THE SANDER.
Having changed the belt, it is
important to make sure that the belt
runs square on the rollers. This is
achieved by adjusting the tracking.
TO ADJUST THE TRACKING, PROCEED
AS FOLLOWS:
1. Switch on the belt sander.
2. Adjust the tracking screw until the
sanding belt is running in line with
the flat side of the tool.
3. Turn the screw anti-clockwise to
run the belt into the tool. Turn the
screw clockwise to run the belt
away from the tool.
FITTING THE DUST COLLECTION BAG
When using the belt sander, certain materials will generate harmful or toxic
dusts and grit. For this reason it is important to fit the dust collection bag. Do
not allow the dustbag to get too full. Empty the bag before it becomes
overloaded.
1. Put the plastic nozzle of the dust
collection bag over the dust
extraction outlet.
2. Push firmly home.
3. To empty the dust bag, grasp the
bag by the plastic nozzle and pull
away from the dust extraction
outlet.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
8
Advertisement
Table of Contents
