York YEFE BZTM-MOW1 Series Service Manual page 81

Procedure
3) Remove the hex nuts and washers securing
the compressor, located on the bottom
plate (see CJ_ODU_019 ).
4) Heat up the brazed parts and then remove
the the discharge pipe and the suction
pipe (see CJ_ODU_020 ).
5) Lift the compressor from the base pan
assembly with pliers.
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
CJ_ODU_019
Discharge Pipe
CJ_ODU_020
Suction Pipe
 Page 77 