Toshiba SUPER MMK-AP0073H (IN) Service Manual page 17

1
n How to set up the wind direction
1
SWING/FIX
Push during operation.
The wind direction changes for every push of
the button.
[In HEAT operation]
Direct the louver (adjustment plate of up/down wind
direction) downward.
If directing horizontally, hot air
may not come to the foot.
[In COOL/DRY operation]
Direct the louver (adjustment plate of up/down
wind direction) horizontally.
If directing it downward, the dew
may form on the surface of the air
discharge port and may drop down.
[In FAN operation]
Select a desired wind direction.
n How to start swinging
1
SWING/FIX
Push , set the louver (adjustment plate
of up/down wind direction) direction to the
lowest position, and then push
SWING is displayed and the up/down wind
direction is automatically selected.
Display during swinging
Repeat
TIMER SET
TIME
FILTER
RESET TEST SET CL
Initial setup
Initial setup
Initial setup
SWING/FIX
again.
17
FAN MODE
SAVE VENT
SWING/FIX UNIT LOUVER
n How to stop swinging
1
SWING/FIX
Push at a desired position while the
louver is swinging.
SWING/FIX
• When is pushed after that, wind direction
can be set again from the highest position.
∗ However, even if
louver is swinging, the louver position is
displayed as follows and highest position of
the louver may not be selected.
Display when swinging is stopped
FAN/HEAT
operation
SWING/FIX
In this case, push
• In COOL/DRY operation, the louver does not
stop as it directs downward.
If stopping the louver as it directs downward
during swing operation, it stops after moving
to the third position from the highest position.
Display when stopping the swing
FAN/HEAT
operation
Unit select button
• When multiple indoor units are controlled with one
remote controller, wind direction can be set for
each indoor unit by selecting individually.
• To set wind direction individually, push
button to display an indoor unit number in the
control group. Then set the wind direction of the
displayed indoor unit.
• When no indoor unit number is displayed, all
indoor units in the control group can be controlled
simultaneously.
• Each time you push
changes as follows:
Unit No. 1-1
No display
Unit select button
SWING/FIX
is pushed while the
COOL/DRY
operation
again two seconds later.
COOL/DRY
operation
UNIT LOUVER
UNIT LOUVER
button, the display
Unit No. 1-2 Unit No. 1-3
Unit No. 1-4