Cc-Link Ie Tsn Configuration - Mitsubishi Electric FR-E800 Instruction Manual (Communication

• When both authentication class B and class A products are used, the data size of all class A units must not exceed 2k bytes
for cyclic transmission. Up to 10 authentication class A units can be connected per port on the master station.
RJ71GN11-T2
Communication
speed 1 Gbps
• When the master station has more than one port, use separate ports for both authentication classes to enable connection of
up to 120 slave station units. For example, use port 1 for authentication class B products only, and port 2 for class A products
only.
RJ71GN11-T2
(firmware version
"12" or later)
Communication
speed 1 Gbps
• For details of network configurations, refer to the Master Module User's Manual.
 Related manuals
MELSEC iQ-R CC-Link IE TSN User's Manual (Startup)
MELSEC iQ-R CC-Link IE TSN User's Manual (Application)
MELSEC iQ-F FX5 User's Manual (CC-Link IE TSN)
MELSEC iQ-R Motion Module User's Manual (Startup)
MELSEC iQ-R Motion Module User's Manual (Application)
2.5.2

CC-Link IE TSN configuration

 Procedure
The following shows the procedure to connect the inverter with a Mitsubishi Electric master device.
 Before communication
1.
Connect each unit with an Ethernet cable. (Refer to
2.
Enter the IP address (Pr.1434 to Pr.1437). (Refer to
3.
Set "45238" (CC-Link IE TSN) in any of Pr.1427 to Pr.1430 Ethernet function selection 1 to 4. (Refer to
In the initial status, Pr.1429 = "45238" (CC-Link IE TSN) and setting is not required.
4.
Reset the inverter, or turn OFF and then ON the power.
 Registering a profile
1.
Start the engineering software (GX Works3).
2.
On the menu bar, select [Tool] > [Profile Management] > [Register...].
3.
Select a CSP+ file to be registered on the "Register Profile" screen, and click the [Register] button.
20
2. Ethernet Communication
2.5 CC-Link IE TSN
Remote I/O General-purpose
(authentication switching hub
class B)
Communication
speed 1 Gbps
Port 1
Port 2
General-purpose
switching hub
Name
page
FR-E800 (authentication class A)
Communication speed 100 Mbps
10 units maximum
Remote I/O
Total number of
(authentication
slave stations:
class B)
120 units maximum
Communication
speed 1 Gbps
FR-E800 (authentication class A)
Communication speed 100 Mbps
Manual number
SH-082127ENG
SH-082129ENG
SH-082215ENG
IB-0300406ENG
IB-0300411ENG
15.)
page 17.)
page 26.)