Husqvarna Automower 210 C Technical Manual page 51

3.4.2 Test OUT (3-2-5)
The Test OUT (3-2-5) function is used to try different
charge exit settings and to find out how far it is from
the charging station to a remote area.
To test the settings for Follow loop out (3-2-1):
1. State the value 100 % for Proportion for the
remote area to be tested.
2. Place Automower
®
select Test OUT (3-2-5).
The mower will now leave the charging station
directly according to the stated direction and
start mowing after the stated distance.
3. Reset the Proportion value when testing is
finished.
To find out the distance from the charging station to a
remote area:
1. State a distance that easily exceeds the true
distance. The maximum distance that can be
stated is 500 metres (1600 ft).
2. State the value 100 % for Proportion for the area
to which the distance is to be measured.
3. Place Automower ®
select Test OUT (3-2-5).
The mower will now leave the charging station
directly according to the stated direction. The
distance will be shown on the display, stated in
metres, as the mower runs.
4. Stop the mower after the required distance and
read the distance.
Reset the Proportion value when testing is
5.
finished.
To test the settings in Exit angles:
1. State the value 100 % for Proportion first when
sector 1 is to be tested. State the value 0 % for
Proportion first when sector 2 is to be tested. All
areas below Follow loop out must be set to 0 % as
well.
2. Place Automower ®
select the Test OUT (3-2-5) function.
The mower will now leave the charging station
directly according to the settings under Exit
angles.
Reset the Proportion first value when testing is
3.
finished.
3. INSTALLATION
in the charging station and
in the charging station and
in the charging station and
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
3-2-4
English - 51