The Tools Menu, Functions; Operating History (5-1) - Husqvarna Automower 210 C Technical Manual

2.7 The Tools menu, functions

Via the Tools menu you can access data about the
mower's function, test functions and special settings.
As in other menus the selections you make are
shown as a numerical series in the bottom right
corner of the display. Select:
•

Operating history (5-1),

to show key data, this give an overview of a
mower's age and function.
• Test (5-2),
to actively test the mower's different components
and functions.
• Live data (5-3),
to study an Automower
is not in test mode, but is checked by its own
mower program.
• Demo mode (5-4), (only 220 AC and 230 ACX ,
without GSM software)
to be able to demonstrate the Automower
mowing.
• Loop detection (5-5),
to turn off the mower's loop detection and in doing
so be able to run the Automower
the boundary wire.
• Special settings (5-6),
to adjust the square mode cutting function, return
the mower back to the start-up sequence, calibrate
the tilt sensor and override STOP button.
2.7.1 Operating history (5-1)
Only on 220 AC, 230 ACX and Solar Hybrid. For 260
ACX, this information is displayed via Autocheck. You
can use the values shown in this sub-menu to see how
well the mower has worked. When a value deviates
from the norm, this may be due to an installation defect
or a fault on the mower.
The sub-menu consists of four part menus that
contain information about the mower's operation.
32 - English
2. SPECIAL MENU FUNCTIONS
® in operation, i.e. when it
®
without installing
®
Commands
Timer
Garden
Settings
Tools
without
Operating history
Test
Live data
Demo mode
Loop detection
Special settings
Operating history
Test
Live data
Demo mode
Loop detection
Special settings
Operating data
Trip Op. counters
Fault messages
Software
Battery history
5-1
5-
5-1-