Technical Description; Installation; Operation - Dometic TBW203 Operating Manual

TBW203
5

Technical description

The built-in cooler is suitable for mobile use. You can keep items cool at up to 20 °C
below the ambient temperature (thermostat switches off at around +5 °C).
Its cooling system is a non-wearing Peltier cooling system with the heat discharged
by a fan.
I
NOTE
The cooling function of the box is switched off if the input voltage falls
below 11.6 V. The cooling function is only activated again when the
input voltage is at least 12.1 V.
6

Installation

Note the following instructions when fitting the built-in cooler in the vehicle:
• Install the cooler in a dry, sheltered place (dimensions: fig. 1, page 2).
• Avoid installing the devices next to heat sources such as heaters, gas ovens, hot
water pipes, etc.
• The device must be installed so that heated air from the cooling unit can dissipate
easily. Therefore make sure there is adequate ventilation.
7

Operation

I
NOTE
Before starting your new cooler for the first time, you should clean it
inside and outside with a damp cloth for hygienic reasons (chapter
"Cleaning and maintenance" on page 8).
7.1 Energy saving tips
• Choose a well ventilated installation location which is protected against direct
sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
EN
Technical description
7