Siemens SENTRON 7KT PAC1600 Equipment Manual page 51

4. Press the "Next" key to access the selected menu.
5. Select the submenu (where applicable) and the serial parameter number.
6. After setting the required parameter, you can use the "Next" key to switch to edit mode.
Use the keys as follows:
– Press the "Increase" or "Decrease" key to change the parameter within the permissible
– Simultaneously press the "Increase" and "Decrease" keys to set the minimum possible
– Simultaneously press the "Increase" and "Decrease" keys to set the maximum possible
– Simultaneously press the "Increase" and "Decrease" keys to restore the factory default
The required value is selected.
7. Press the "Next" key to save the parameter.
The display returns to the previous menu level.
8. Press the "Increase" and "Decrease" keys repeatedly to exit and save the parameters.
The device is rebooted.
Note
If you do not press any key for a period of 2 minutes, the system exits the setup menu and
returns to the standard display without saving the parameters.
Note
The devices allow you to create a backup copy in EEPROM, but only of the data which can
be edited using the keys. You can write this data back into RAM if required.
You can find the backup and data restore commands in chapter Command menu
(Page 64).
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
range.
value.
value.
value.
Description
3.5 Three-phase devices 5 A
49