Keypad Functions - Siemens SENTRON 7KT PAC1600 Equipment Manual

Basic properties
• DIN rail enclosure, 2 MW (36 mm wide)
• Direct connection for currents up to 63 A
• LCD with backlighting
• 6-digit counter with one place after the decimal point
• Key for selecting measured quantities and for setting parameters
• Active energy meter and reactive energy meter
• Partial meter for active and reactive energy
• Hour counter
• Pulse LED for active energy consumption
• Display of instantaneous consumption (active power)
• Optional: RS 485, M-Bus or S0 interface
• Optional: MID certification
3.3.1

Keypad functions

You can operate the device with the front key.
The front key is assigned different functions.
The function of the front key depends on the menu level currently in use.
Navigation with front key
1. To open the menu, press the front key (> 5 s).
2. Press the front key (> 3 s) while SETUP is visible on the display.
The first parameter code P-01 appears on the display.
3. Press the front key briefly to move to the next parameters (e.g. P-02, P-03).
4. When the code for the parameter you wish to change appears on the display, press the front
key (> 3 s).
– If this is a numeric parameter (password, threshold values, delays), the current value
– If the parameters make it possible to select between different functions (e.g. output
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
appears on the display. The individual digits flash in succession.
While a digit is flashing, you can increase that number by pressing the front key. The
selection waits a few seconds for the next digit.
functions, measurement), you can select the required function by repeatedly pressing
the front key.
Description
3.3 Single-phase devices
19