Prime Line Preference; Prime Line Enhancements; Programming - NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
Enhanced Features in 02.10.09

Prime Line Preference

Prime Line Enhancements

Programming

44 N 02.10.09
With this software release, Idle Prime Line Preference is enhanced as follows:
G
An extension's Idle Prime Line can be any trunk or trunk group, regardless of whether the
extension has a line or loop key for the trunk or group. If the Prime Line is for a trunk or
group, the extension user cannot use the #PLA User Programmable Feature to customize the
setting.
G
Idle Prime Line to any trunk or trunk group is available at single line telephones.
Intercom Prime Line works the same as in previous releases, although with this software release it
is programmed differently. Intercom Prime Line is the default setting.
1807-Prime Line Type
Use this option to set the Prime Line type at an extension. The options are:
G
Key (1)
The Prime Line is associated with a key on the phone, assigned in 1807-Prime Line Key.
This is the default setting.
G
Line (2)
The Prime Line is a trunk or trunk group, assigned in 1807-Prime Line/Line Group.
G
None (0)
There is no Prime Line assignment. Nothing happens when the user lifts the handset.
At single line extensions, any entry other than Line (2) provides Intercom Prime Line.
When entering data, pressing:
G
CLEAR enables Intercom Prime Line.
G
CHECK restores previous entry.
G
Vol Up or Vol Down scrolls through the available entries.
1807-Prime Line Key
If 1807-Prime Line Type is set to Key (1), use the option to select the key assigned as the exten-
sion's Prime Line key. The options are:
G
0 (None)
There is no Prime Line Key assignment.
G
1-24 (Programmable Function Key 1-24)
The extension seizes the trunk or group assigned to the designated key when the user lifts the
handset.
G
ICM
This enables Intercom Prime Line. The extension user hears Intercom dial tone when they lift
the handset. This is the default setting.
This option does not apply to single line telephones.
When entering data, pressing:
G
CLEAR enables Intercom Prime Line.
G
CHECK restores previous entry.
DS1000 Release Notes