Enhanced Features In 02.10.09; Call Forwarding; Call Forwarding Key; Confirmation Tone Added - NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes

Enhanced Features in 02.10.09

Enhanced Features in 02.10.09
Enhanced Features in 02.10.09

Call Forwarding

Call Forwarding Key

Confirmation Tone Added

Soft Key And Type Enhancements

20 N 02.10.09
A keyset user can have a key on their telephone or DSS Console assigned as a Call Forwarding key.
G
While the extension is idle, pressing the key puts the extension in the Call Forwarding pro-
graming mode - the same as pressing ICM and dialing *3.
If the extension has Call Forwarding enabled, and the user presses the key and waits
(for at least 6 seconds), Call Forwarding is automatically cancelled.
If the extension has Call Forwarding disabled, and the user presses the key and waits
(for at least 6 seconds), the prior Call Forwarding mode is automatically enabled (if any).
G
While the extension is busy, pressing the key switches Call Forwarding on and off.
This flash rate:
Off
Fast flash
Wink off
Note: The new display CFWD Not Allowed indicates that an Call Forwarding is denied because it
would set up an illegal Call Forwarding loop. For example, if extension 305 if forwarded to 301,
and 301 attempts to forward to 305, the user at 305 would see the display CFWD Not Allowed .
Programming
1701-Programmable Function Key Assignments
For keysets, assign a programmable key as a Call Forwarding key (code 27).
1704-DSS Console Key Assignment
For DSS Consoles, assign a key as a Call Forwarding key (code 27).
Keyset users will hear a single confirmation beep after enabling or cancelling Call Forwarding. Sin-
gle line telephone users will hear Intercom dial tone after enabling or cancelling Call Forwarding.
In prior software versions, extension users would have no audible indication that they successfully
completed the Call Forwarding steps.
When setting up Call Forwarding, display keyset users can dial codes from the dial pad or use their
soft keys.
You can set up Call Forwarding to reroute all calls or just trunk calls. If an extension with forwarding
set for trunk calls only receives a screened Transfer, the initial voice-announcement broadcasts at the
extension. When the caller hangs up to complete the transfer, the trunk call forwards as programmed.
Call Forwarding Key BLF
Call Forwarding is disabled.
The extension is in the Call For-
warding programming mode.
Call Forwarding is enabled at the
Means:
extension
DS1000 Release Notes