Zanussi ZWGB 7140 AS User Manual page 9

Before connecting up the appliance to new pi-
pework or to pipework that has not been used
for some time, run off a reasonable amount of
water to flush out any debris that may have col-
lected
The inlet hose is supplied and can been found
inside the machine drum.
Do not use the hose from your previous appli-
ance to connect to water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose
with the angled con-
nection to the ma-
chine. Do not place
the inlet hose down-
wards. Angle the
hose to the left or
right depending on
the position of your
water tap.
3. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose be sure to
tighten the ring nut again to prevent leaks.
4. Connect the hose
to a tap with a 3/4"
thread.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
www.zanussi.com
Water-stop device
The inlet hose is pro-
vided with a water
stop device, which
protects against dam-
age caused by water
leaks in the hose
which could develop
due to natural ageing
of the hose.
This fault is shown by a red sector in the win-
dow «A». Should this occur, turn the water tap
off and refer to your Service Centre to replace
the hose.
Water drainage
Firstly form a hook in the end of the drain hose
using the plastic hose guide supplied with the
appliance .
The end of the drain hose can be positioned
in four ways:
• Hooked over the edge of a sink using
the plastic hose guide.
Tie the plastic hose guide to the tap with a
string to prevent that the drain hose unhooks
when the appliance is emptying.
• Onto a sink outlet spigot.
A
9