Bradford White EFR-1-60T1206EN Installation & Operating Manual page 52

ACCESSING SERVICE MODE ON THE WATER HEATER DISPLAY (FOR SERVICE
PERSONNEL ONLY)
The display has a "Service Mode" for changing the maximum setpoint and accessing information in aiding servicing of the water
heater. This procedure is for service and installation personnel only. To enter the Service Mode, follow the steps illustrated below:
The following procedure is for service and installation personnel only. Resetting lockout conditions without
correcting the malfunction can result in a hazardous condition.
Step 1: Press "Select" and "Temperature Up" buttons together and hold for 3 seconds until "Max Setpoint" is shown in
the display.
30 Seconds after the last button press, the display will automatically return to the "User Mode". Simultaneously
pressing the "Select" and "Temperature Up" buttons will switch the display immediately to the "User Mode".
Step 2: Pressing "Select" button will change display to next mode
WARNING
Max
°F
Setpoint
idle
Operational
Status
SELECT SET
NOTICE
Water
°F
Temp
idle
Operational
Status
SELECT SET
52
"Max Setpoint"
next to Temperature
Setpoint value.